Altronix AL300ULMR Multi-Output Power Supply/Charger

5 Output Power Supply/Charger w/Fire Alarm - 12VDC or 24VDC @ 2.5 amp, PTC Class 2 power limited outputs, red encl. 13.5"H x 13"W x 3.25"D., 115VAC input, UL Listed (UL294/UL603/UL1069/UL1481), cUL Listed, MEA & CSFM Approved. AL300ULMR multi-output access control power supply/charger is specifically designed for use with access control systems and accessories. This unit converts a 115VAC / 60Hz input into five (5) individually protected Class 2 Rated power limited 12VDC or 24VDC outputs. Each output will route power to a variety of access control hardware devices including Mag Locks, Electric Strikes, Magnetic Door Holders, etc. These outputs will operate in both Fail-Safe and Fail-Secure modes. Controlled trigger input is achieved through normally open (N.O.) or normally closed (N.C.) supervised input or the polarity reversal from an FACP (Fire Alarm Control Panel). A form "C" dry output relay enables HVAC Shutdown, Elevator Recall or may be used to trigger auxiliary devices.

• Input 115VAC / 60Hz, 3.5 amp
• Input fuse rated @ 3.5 amp/250V
• Fire Alarm Panel or Access Control System trigger inputs. N.O. or N.C.supervised trigger input and polarity reversal trigger input
• 12VDC or 24VDC selectable outputs
• 2.5 amp supply current
• Five (5) PTC protected outputs, rated @ 2 amp
• Output relay energizes when unit is triggered (form "C" contact rated 1 amp @ 28VDC)
• Filtered and electronically regulated output
• Short circuit and thermal overload protection
• Built-in charger for sealed lead acid or gel type batteries
• Automatic switch over to stand-by battery when AC fails
• Maximum charge current 0.7 amp