Altronix HubWay8D 8 Channel Passive UTP Transceiver Hub, 115/230VAC

***HubWay8D has BNC connectors on the rear and CAT-5 connectors on the front***

**AC (HubWayAv) and/or DC (HubWayDv/HubWayDvi) video balun/combiners required.**

Altronix HubWay8D passive (non-amplified) UTP transceiver hub with integral camera power transmits UTP video, RS422/RS485 data and power over a single CAT-5 or higher structured cable. Unit provides 8 camera channels in a space saving 1U EIA 19" rack mount chassis which may be rack, wall or shelf mounted. Video transmission range is up to 750 ft. max. per channel. Units are compatible with AC and/or DC fixed or PTZ cameras when utilizing Altronix HubWayAv, HubWayDv or HubWayDvi video balun/combiners. In addition, the unit features individually selectable 24VAC or 28VAC PTC protected outputs with surge suppression. An optional HubSat4D passive (non-amplified) UTP transceiver hub with integral camera power can be used as an accessory module to transmit video from up to 4 cameras over a single CAT-5 or higher structured cable back to the HubWay8D. In addition, the HubSat4D provides power to these cameras locally to eliminate the possibility of voltage drop associated with long cable runs.

Features:

Individually selectable 24VAC or 28VAC power outputs with OFF position.
Unit provides up to 1 Amp max. per channel not to exceed a total of 5 Amp (150VA) maximum current.
PTC protected outputs. PTCs are rated @ 1 Amp per channel.
Class 2 Rated power limited outputs.
Surge suppression.
Primary fuse (internal) is rated at 5 Amp/250V.
Input: 115VAC 60Hz, 1.5 Amp or 230VAC 50/60Hz, 1 Amp.
Data: RS422/RS485 data input.
Video: Eight (8) channels of video over twisted-pair up to 750 ft. Eight (8) 75 Ohm composite video outputs.
AC input power indicator.
Eight (8) individual power LED indicators.
Illuminated master power disconnect circuit breaker with manual reset.
IEC-320 - 3-wire grounded line (power) cord (detachable).
Rack, wall or shelf mount.
Optional HubSat4D allows transmission of up to four (4) video signals over a single CAT-5 or higher structured cable.
AC (HubWayAv) and/or DC (HubWayDv/HubWayDvi) video balun/combiners required.
Lifetime Warranty.