Altronix MAXIMAL33FD 2 Pwr Supply/Charger w/ Access Power Controllers

Maximal33FD Access Power Controller distributes and switches power to access control systems and accessories. It converts a 120VAC 60Hz input into sixteen (16) independently controlled 12VDC or 24VDC PTC protected power limited outputs. The outputs are activated by an open collector sink or normally open (NO) dry trigger input from an Access Control System, Keypad, Push Button, REX PIR, etc. Unit will route power to a variety of access control hardware devices including: Mag Locks, Electric Strikes, Magnetic Door Holders, etc. Outputs will operate in both Fail-Safe and/or Fail-Secure modes. The FACP Interface enables Emergency Egress, Alarm Monitoring, or may be used to trigger other auxiliary devices. The fire alarm disconnect feature is individually selectable for any or all of the sixteen (16) outputs. All interconnecting equipment must be UL Listed.

• Low battery cutoff
• Over voltage protection (OVP)
• AC & battery monitoring
• Encl. 26"H x 19"W x 6.25"D
• 115VAC input
• Accommodates up to 4 - 12VDC/12AH batteries
• UL Listed (UL294), cUL Listed (ULC-S319-05), CSFM Approved
• Fire Alarm disconnect (latching or non-latching) is individually selectable for any or all of the sixteen (16) outputs
• Fire Alarm disconnect input options:

a) Normally open (NO) or normally closed (NC) dry contact input

b) Polarity reversal input from FACP signaling circuit

• Alarm output relay indicates that FACP input is triggered (form "C" contact rated @ 1 amp 28VDC)