Bogen MIC1X Transformer-Balanced Microphone XLR Input Module

The MIC1X module shall have a transformer-isolated, balanced input with XLR connector. It shall interface with low-impedance dynamic microphones. It shall also interface with electret condenser microphones and shall have an internal 24V DC phantom power supply to provide the bias supply that is enabled by a PCB jumper. The module shall have a gain control that will allow the gain to be adjusted from 28 dB to 62 dB. It shall have the ability to mute lower priority modules and be muted by higher priority modules. The module shall be able to assume any of 4 priority levels. The module shall have a VOX/gating circuit to control muting of lower priority modules and its internal gating circuit with controls for threshold and duration. It shall have a built-in limiter, with a threshold control, to limit the maximum output level of the module. A front panel LED will indicate limiter activity. The module shall have bass and treble controls with cut or boost of 10 dB at 100 Hz and 10 kHz, respectively. The module’s output shall be assignable to either or both of two mixing buses.

• Gain/Trim control
• Bass & Treble controls
• Noise gate w/Threshold & Duration
• Limiter w/Threshold control
• Limiter activity LED
• 24V Phantom power
• Mute send & receive
• 4 Priority levels
• Bus assignable
• Balanced, transformer-isolated
• XLR connector