Panasonic T1MK1F4SMC Access Control Power Supply Includes TROVE1M1, EFLOW4NB, ACM4, VR6, PDS8, Cam-Lock Mounting Hardware, Panasonic Ipro Logo

Trove1M1 accommodates various combinations of Mercury boards with or without power supplies and accessories for access systems.

eFlow4NB UL Listed Sub-Assembly power supply/charger converts 120VAC, 60Hz input into a single 12VDC or 24VDC Class 2 Rated power-limited output. It also offers a suite of features that includes fire alarm disconnect, overvoltage protection, and low power disconnect which prevents deep discharge of stand-by batteries.

ACM4 converts one (1) 12 to 24 VAC or VDC input into four (4) independently controlled fuse protected outputs. These power outputs can be converted to dry form "C" contacts. Outputs are activated by an open collector sink or normally open (NO) dry trigger input from an Access Control System, Card Reader, Keypad, Push Button, PIR, etc. ACM4 will route power to a variety of access control hardware devices including Mag Locks, Electric Strikes, Magnetic Door Holders, etc. Outputs will operate in both Fail-Safe and/or Fail-Secure modes. Units are designed to be powered by one common power source which will provide power for both the board operation and locking devices, or two (2) totally independent power sources, one (1) providing power for board operation and the other for lock / accessory power. The FACP Interface enables Emergency Egress, Alarm Monitoring, or may be used to trigger other auxiliary devices. The fire alarm disconnect feature is individually selectable for any or all of the four (4) outputs.

VR6 Voltage Regulator converts a 24VDC input into a regulated 5VDC or 12VDC selectable output at up to 6A supply current. It reduces the cost of adding an additional power supply to achieve 24VDC and 12VDC or 5VDC simultaneously.

PDS8 dual input power distribution modules are designed to steer the power from either two (2) low voltage AC or DC power sources. This power is distributed over a total of eight (8) fused protected outputs.

Features

Trove1 enclosure with TM1 & Mercury backplane

• Backplane accommodates a combination of Mercury controllers with or without accessories:
  - Mercury: LP1501, LP1502, MR50, MR51e, MR52, MR16IN, MR16OUT
  - Power Supplies
  - Sub-Assemblies
• Includes Trove1 Enclosure and one (1) removable TM1 backplane

eFlow4NB Features

• Input 120VAC 60Hz, 3.5A
• Class 2 Rated power-limited output
• 12VDC or 24VDC selectable output
• 4A continuous supply current
• Aux. Class 2 Rated power-limited output rated @ 1A (unswitched)
• Overvoltage protection
• Filtered and electronically regulated outputs
• Built-in charger for sealed lead acid or gel type batteries
• Automatic switch over to stand-by battery when AC fails. Transfer to stand-by battery power is instantaneous with no interruption