Panasonic T2MK77F16QMC Access Control Power Supply Includes TROVE2M2, 2X EFLOW104NB, 2X ACM8, VR6, PDS8, LINQ2, CAM-LOCK, MOUNTING HARDWARE, PANASONIC IPRO LOGO

Trove2M2 accommodates various combinations of Mercury boards with or without power supplies and accessories for access systems.

eFlow104NB UL Listed Sub-Assembly power supply/charger converts a 120VAC, 60Hz input into a single 24VDC output. It also offers a suite of features that includes fire alarm disconnect, overvoltage protection, and low power disconnect which prevents deep discharge of stand-by batteries.

ACM8 converts one (1) 12 to 24 volt AC or DC input into eight (8) independently controlled fuse protected outputs. These power outputs can be converted to dry form "C" contacts. Outputs are activated by an open collector sink or normally open (NO) dry trigger input from an Access Control System, Card Reader, Keypad, Push Button, PIR, etc. ACM8 will route power to a variety of access control hardware devices including Mag Locks, Electric Strikes, Magnetic Door Holders, etc. Outputs will operate in both Fail-Safe and/or Fail-Secure modes. This unit is designed to be powered by one common power source which will provide power for both the board operation and locking devices, or two (2) totally independent power sources, one (1) providing power for board operation and the other for lock / accessory power. The FACP Interface enables Emergency Egress, Alarm Monitoring, or may be used to trigger other auxiliary devices. The fire alarm disconnect feature is individually selectable for any or all of the eight (8) outputs.

VR6 Voltage Regulator converts a 24VDC input into a regulated 5VDC or 12VDC selectable output at up to 6A supply current. It reduces the cost of adding an additional power supply to achieve 24VDC and 12VDC or 5VDC simultaneously.

PDS8 dual input power distribution modules are designed to steer the power from either two (2) low voltage AC or DC power sources. This power is distributed over a total of eight (8) fused protected outputs.

Features

Trove2 enclosure with TM2 & Mercury backplane

• Backplane accommodates a combination of and Mercury boards:
  - Mercury: LP1502, MR52, MR16IN, MR16OUT, LP2500, MUX8, MR51e, LP1501, MR50, and Genetec Synergis Cloud Link
  - Power Supplies
  - Sub-Assemblies
• Includes Trove2 Enclosure and one (1) removable TM2 backplane
• Door accommodates TMV2 backplane (sold separately)

eFlow104NB Features

• Input 120VAC 60Hz, 4.5A
• 24VDC output
• 10A continuous supply current
• Aux. power-limited output rated @ 1A (unswitched)
• Over Voltage Protection
• Filtered and electronically regulated outputs
• Built-in charger for sealed lead acid or gel type batteries
• Automatic switch over to stand-by battery when AC fails. Transfer to stand-by battery power is instantaneous with no interruption
• Supervised Fire Alarm disconnect (latching or nonlatching) 10K EOL resistor. Operates on a normally open (NO) or normally closed (NC) trigger